Hello
I wanted to know if there is a way to adjust the "angle of the line" via a properties setting. I am trying to draw a simple line in a flow chart but the line is not 90 degrees. There is a little bump as seen below.
Suggestions?
Line Angle
+3Hi Luigi
Could you try holding L while drawing the line?
Hi Kristy
It worked. Thanks for your help
Luigi
Create an account in the community
A Lucid account is required to interact with the Community, and your participation is subject to the Supplemental Lucid Community Terms. You may not participate in the Community if you are under age 18. You will be redirected to the Lucid app to log in.
Log in to the community
A Lucid account is required to interact with the Community, and your participation is subject to the Supplemental Lucid Community Terms. You may not participate in the Community if you are under age 18. You will be redirected to the Lucid app to log in.
Log in with Lucid
or
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
